Features
- Original Loxone replacement actuator
- Suitable for the Loxone Damper Tree, also our European version
- Connection via Loxone Tree
- Can be used directly at the HC output of the Intelligent Room Controller
Technical data actuator
- Supply: 15 … 30 V DC
- Power consumption: 0.2 W, max. 2.3 W with the motor running
- Interface: Loxone Tree
- Conductor cross-section: 0.25 … 0.8 mm²
- Stripping length: 5 mm
- Connection: orange/white = +24 V DC/GND, green/white = Loxone Tree
- Ambient temperature: 0 … 55 °C
- Humidity: max. 95 % RH (non-condensing)
- Degree of protection: IP20
- Maintenance-free
Wiring diagram

Commissioning
- Connect the supply (15–30 V DC) and the Tree cable to the actuator.
- Switch on the power: the LED flashes orange, the motor is connected but not yet paired.
- Search for the damper in Loxone Config like any Tree device and pair it with the Miniserver. The LED then flashes green three times briefly.
- Connect the damper to the HC output of the Intelligent Room Controller. The “Online status” output is available for troubleshooting.
LED states
| Red, flashing evenly | No Tree connection, check wiring |
|---|---|
| Orange, flashing evenly | Connected, but not yet paired with the Miniserver |
| Green, three short flashes | Paired, connection OK |
| Green, flashing rapidly | Online, damper less than 25 % open |
| Orange, flashing rapidly | Online, damper between 25 and 75 % open |
| Red, flashing rapidly | Online, damper more than 75 % open |
Note
Installation must be carried out by a qualified specialist and must comply with the regulations on electrical and fire protection.
